Fiber Fusion Splicer discharge not how to do

Fiber Fusion Splicer This is not because the electrode discharge aging, the relative orientation of the fiber with an arc or change the operating environment has caused major changes. Disposal are as follows:

Fiber Fusion Splicer discharge not how to do

Fiber Fusion Splicer discharge not how to do

rencontre airsoft 2013 starstruck rencontre avec une star le film en entier site rencontres belgique gratuit link rencontre a quebec gratuite http://www.pioneervillage.org/wifer/4341 rencontres 59 regarder le film starstruck rencontre avec une star en streaming vf http://www.livingislam.co.za/vilki/2775 post sex dating Fiber Fusion Splicer discharge not how to do
1. The electrode aging conditions. Check whether there is damage to the electrode tip, if not then a “clean electrode” operation. If the electrode tip damage, replace the electrode.
KeyWords: Fusion splicer
2. Fiber arc relative position change of circumstances. Enter the “maintenance mode” menu, press the “arc position” to open the windshield can be observed with optical fiber arc relative position, if the optical fiber is not in the middle of electricity may be conducted several “clean electrode” operation, and then observe whether the fiber and the relative position of the arc changes. If compared with the same stable position.
3. The operating environment has changed greatly.

Website: http://www.aitelong.com/

Comments are closed.