How to use fiber cleaver and fusion splicer to splicing a fiber?

Fiber optics are thin glass rods that communicate information in the form of light. They can be used in telecoms, internet-connections or medical-equipment. You can splice these fibers together with a fiber cleaver and fusion splicer to create one continuous path for the light. Today we will learn optical fiber splicing using a fiber pair.

Fiber Cleaver and Fusion Splicer for Fiber Optic Splice

Equipment A fiber cleaver is a device that cuts the fibers precisely at the place of splicing. And you know, it’s fans out there on the outside cuts to help create a flat and clear finish of the pack on your fiber which is important in captive side the terminals. The ends of the fibers can be melted together and an optical fusion splicing will use to melt and fuse them into a single homogeneous piece. This can insure a little loss of signal and the high efficiency of information transmission.

How to Use Fiber Cleaver for Prepping the Fiber Prior Splicing, It’s Some Steps That Be Followed on Prepping the Fiber

1.  Also, tear the casing of the fiber optics which shows you the glass core inside.

2.  Insert the fiber into the cleaver, then rotate it to optimal cutting position.

3.  Apply downward pressure and you will have a clean, accurate cut on the fiber.

4.  Pick away the unnecessary fiber strands so there’s nice clean surface to splice.

Hacks and Tips to Build the Strongest Relationships

Be sure to use fiber cleaning supplies before cutting and splicing to prevent the dust or dirt from residue affected by spur connection.

● The end face of the fiber is opened and tested under magnifier before splicing.

● Make sure the fiber optic is properly aligned when melting lest you lose signal.

Utilization of the Appropriate Tools and Techniques for Accurate Fiber Splicing

● Calibration: Make sure you can be as accurate and reliable cobb fusion splicer calibrated, to get the correct and accurate results.

● Fiber clamps keep the fibers stably attached both and aligned during splicing.

● Be careful on the manufacture instruction not to damage the fiber and the fiber splicer.

What Mistakes Should You Avoid When Operating Fiber Cleaver and Fusion Splicer to Do the fiber splicing?

·Attenuation can be very bad if the fiber is cut at an angle.

·It cannot clean fibers while without the need to disassemble instrument.

·Over fusion during fusing splicing can cause fiber to break down and shortens the life.

And finally, when splicing fiber optics, you had better use a good cleaver and fusion splicer and do it with some skill! When you connect with the step-by-step instruction, tips & tricks, and avoiding common mistakes then you can develop strong connections to ensure that everything in your fiber optic network will run properly. Please use the right tools and methods according to your splice quality or reliability. Splice fiber optic for any telecommunication job done with our AITELONG cleaver, fusion splicer.